Abaone produces all kinds of valves and fittings

Beijing fast connection

Male packing quick connection, size 61, TAL model (Joshi 63) Sohri Buri Lahimi Naniri For any reason, if we think of a quick and low-cost program for cultivation and transfer of fluids, without a doubt, quick connection can be the best possible option.

Polyethylene pipe PE80 diameter 20 mm

Nominal size (mm): 20 technical Working pressure (atm)_SF 1.25 : 10 Working pressure (atm)_SF 1.6 : 7.9 Working pressure (atm)_SF 2 : 6.3 Diagram SDR diameter to wall ratio: 13.6 The composition of the main ingredients MR PE: 80

Female threaded polymer elbow

Female double knee 4 inches

17 screw type connector to threaded pipe (Lee flat)

Screw size (mm): 17 technical Type of connection: flat screw nut The composition of the main ingredients Body material: polypropylene

Interface 16 to washer 12 (162*121) primary fastening

Nominal size (mm): 12 technical Connection type: Push The composition of the main ingredients Body material: polypropylene

Milking machine (DN 100) polymer, plastic tongue, 4 people * 110 mm screw

Nominal size (mm): DN 100 Nominal pressure (bar): 10 Nominal inlet diameter in inches (male): 4 Connection type: male thread * screw Output diameter (mm): 110 Handle condition: short Material of tongue: plastic Warranty: Yes

63 * 3/4 ​​branching belt, polymer, brass thread

A belt clamp is a connection that is used to mount an outlet branch to the pipe and branching through the hole in the pipe wall. The branching belt consists of two main parts, the bottom and the navel (branching), and depending on the size of the belt, it has 2, 4 or 6 galvanized bolts and nuts and is sealed by a rubber o-ring. This connection is one of the suitable connections for branching from the pipeline, and usually, after installing it on the pipe, the hole is drilled using a drill for sizes below 20 mm and a drill bit for sizes above 20 mm. Usually, it is recommended that the hole created in the pipe wall be at most 85% of the diameter of the belt hole, so that there will be no problem in terms of sealing in case of partial displacements of the network.